Installation And Connection - Oase ProMax ClearDrain 7000 Gebrauchsanleitung

Intended use
Only use the product described in this
manual as follows:
• For pumping clear water or rain water.
• For pumping dirty water and max. 5 mm
large particles.
• For irrigating and watering.
• For transferring water from and draining
basins or ponds/pools.
• Extraction of water from a well.
– Only for irrigation and watering pur-
poses!
• For pumping the water out of water
butts/rain barrels or cisterns.
• Operate the product in compliance with
the technical data. (→ Technical data)
The following restrictions apply to the unit:
• Not suitable for salt water.
• Never use for pumping dirty wa-
ter/waste water.
• Not suitable for drinking water.
• Do not connect to the drinking water
supply.
• Do not use for long-term operation (e.g.
continuous recirculation of the water in
a pond).
• Do not use for commercial or industrial
purposes.
• Do not use in conjunction with chemi-
cals, foodstuff, easily flammable or ex-
plosive substances.

INSTALLATION AND CONNECTION

Connecting the pressure hose
An optimum flow rate is achieved with the
largest possible hose inside diameter.
How to proceed:
 B
1. Adapt the stepped hose adapter to the
hose diameter
2. Connect the hose to the stepped hose
adapter.
– Secure the hose with a hose clip.
14
3. Screw the stepped hose adapter onto
the pump outlet.
– As an option, you can use the check
valve (a). The check valve prevents
water in the pressure line from flowing
back into the pump after the pump is
switched off.
Automatic mode ProMax ClearDrain
7000
When the water level rises, it lifts the float
switch until the switch-on point is reached
and the pump switches on.
When the water level drops, the float
switch lowers until the switch-off point is
reached and the pump switches off.
 C
• Push the float switch cable into the ca-
ble clip.
– The shorter the cable between the
float switch and the cable clip, the
lower the switch-on point and the
higher the switch-off point.
N O T E
To ensure faultless function, ensure that
the length of cable between the float
switch and the cable clip measures at
least 10 cm.
N O T E
The minimum residual water height is
only reached in manual mode.
ProMax ClearDrain 7000/11000/14000