Specification - Makita JV100D Betriebsanleitung

ENGLISH
(Original instructions)
1 Battery
2 Buttons
3 Cutting action changing lever
4 Lock-off button
5 Switch trigger
6 Blade holder
7 Bolt
8 Hex wrench
9 Blade

SPECIFICATION

Length of stroke
Strokes per minute (min
Max. cutting capacities
Overall length
Rated voltage
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from
country to country.
• Weight, with battery cartridge, according to EPTA-Pro-
cedure 01/2003
Intended use
The tool is intended for the sawing of wood, plastic and
metal materials. As a result of the extensive accessory
and saw blade program, the tool can be used for many
purposes and is very well suited for curved or circular
cuts.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
CORDLESS JIG SAW SAFETY WARNINGS
1. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring. Cutting
accessory contacting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
Explanation of general view
10 Roller
11 Hook
12 Dust cover
13 Cutting line
14 Base
15 Edge
16 Graduation
17 Starting hole
18 Hose
Model
–1
)
Blade type
Wood
Mild steel
Aluminium
Net weight
2. Use clamps or another practical way to secure
and support the workpiece to a stable platform.
Holding the work by hand or against your body
leaves it unstable and may lead to loss of control.
3. Always use safety glasses or goggles. Ordinary
eye or sun glasses are NOT safety glasses.
4. Avoid cutting nails. Inspect workpiece for any
nails and remove them before operation.
ENE019-1
5. Do not cut oversize workpiece.
6. Check for the proper clearance beyond the work-
piece before cutting so that the blade will not
strike the floor, workbench, etc.
7. Hold the tool firmly.
8. Make sure the blade is not contacting the work-
piece before the switch is turned on.
9. Keep hands away from moving parts.
GEA010-1
10. Do not leave the tool running. Operate the tool
only when hand-held.
11. Always switch off and wait for the blade to come
to a complete stop before removing the blade
from the workpiece.
12. Do not touch the blade or the workpiece immedi-
ately after operation; they may be extremely hot
and could burn your skin.
13. Do not operate the tool at no-load unnecessarily.
14. Some material contains chemicals which may be
GEB045-2
toxic. Take caution to prevent dust inhalation
and skin contact. Follow material supplier safety
data.
15. Always use the correct dust mask/respirator for
the material and application you are working
with.
SAVE THESE INSTRUCTIONS.
19 Rip fence (Guide rule)
20 Fence guide
21 Threaded knob
22 Pin
23 Aluminum base
24 Anti-splintering device
25 Cover plate
JV100D
18 mm
0 – 2,400
B type
65 mm
2 mm
4 mm
231 mm
1.7 kg
D.C. 10.8 V
5