Installations And Connections - Panasonic WV-CP280 Bedienungsanleitung

Installations and Connections

Caution:
ONLY CONNECT THIS TO 24 V AC OR 12 V DC CLASS 2 POWER SUPPLY.
Be sure to connect the grounding lead to the GND terminal. (WV-CP284)
z
Mount the lens (option) by rotating it
clockwise slowly.
x
Connect the lens cable to the ALC lens
connector of the camera.
c
Fix an optional camera mount bracket on to the desired place and mount the camera on it.
• Method of installation may be different depending on the material of the place where the
camera mount bracket is to be installed.
Do not use wood screws to fix the optional camera mount bracket.
• When installing on steel: Fix with bolts and nuts (M8).
• When installing on concrete: Fix with anchor bolts (M8).
Recommended tightening torque: M8: 6.2 N·m {62 kgf·cm}
The mounting requirements are shown as follows.
Mounting place
Ceiling
Wall
• When attaching the mount adapter
removed from the top of the camera on
to the bottom of the camera, do not use
screws other
Otherwise, it may cause a malfunction or
the camera may fall off.
Recommended tightening torque:
0.39 N·m {4 kgf·cm}
12
All manuals and user guides at all-guides.com
Model Recommended
screw
WV-7010A M8
WV-831 M8
than those removed.
ALC lens
connector
Number of Minimum pullout
screws strength (per 1 pc.)
3 pcs. 196 N {20 kgf}
4 pcs. 921 N {94 kgf}
Screw hole
(1/4-20 UNC)
Flange-back
adjustment ring
Lens
(option)
Camera mounting
screws
Mount adapter