Panasonic WV-CP280 Bedienungsanleitung Seite 8

Do not aim the camera at strong light
sources.
A light source such as a spot light causes a
blooming (light bleeding) or a smear (vertical
lines).
Smear
Blooming
Installing place
Contact your dealer for assistance if you are
unsure of an appropriate place in your partic-
ular environment.
Make sure that the installation area is strong
enough to hold the camera, such as a con-
crete ceiling. When the installation area is not
strong enough, reinforce and strengthen it.
Avoid installing in the following locations.
• Locations where it may get wet from rain
or water splash
• Locations where a chemical agent is
used, such as a swimming pool (not only
outdoor)
• Locations subject to steam and oil
smoke, such as a kitchen
• Locations near flammable gas or vapour
• Locations where radiation or x-ray emis-
sions are produced
• Locations subject to strong magnetic
field or radio waves
• Locations where corrosive gas is pro-
duced
• Locations where it may be damaged by
briny air, such as seashores
• Locations where the temperature is not
within –10 °C - +50 °C {14 °F - 122 °F}
8
All manuals and user guides at all-guides.com
Bright subject
• Locations subject to vibrations (this prod-
uct is not designed for on-vehicle use)
• Locations subject to condensation as the
result of severe changes in temperature
Be sure to remove this apparatus if it is
not in use.
Radio interference
When the camera is used near TV/radio
antenna, strong electric field or magnetic
field (near a motor or a transformer), images
may be distorted and noise sound may be
produced.
Mounting screws
It is necessary to procure screws or bolts to
mount the camera. Prepare them according
to the material and strength of the area where
the camera is to be installed. The screws and
bolts must be tightened with an appropriate
tightening torque according to the material
and strength of the installation area.