Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SAT LEVEL control for the satellite speakers
1
SUB LEVEL control for the subwoofer
2
LOW PASS control
3
For adjusting the cutoff frequency (80-200 Hz) for the subwoofer signal and the satellite speakers.
POWER indicator
4
SIGNAL indicator
5
DSP PRESET switch with LEDs
6
To select various equalizer presets according to your application:
Flat = frequency response is not affected, LIVE 1 = high frequency attenuation LIVE 2 = low and
hight high frequency boost, DJ 1 = loudness function, DJ 2 = increased loudness function
Signal input
7
Balanced combo inputs (XLR/6.3 mm jack) for connecting audio units with line level output (e.g.
mixers or preamplifiers).
Feed-through output LINK OUT
8
Balanced XLR jacks, connected in parallel to the inputs, to connect another device, e.g. a further
active speaker system.
Operating mode selector switch
9
• Switch engaged: mono operation
• Switch disengaged: stereo operation
Speaker connectors TO SATELLITE
10
High-pass filtered speaker jacks for connecting the left and right satellite speaker.
Power switch
11
Turns power to the PA system on and off.
Fuse
12
Only replace the fuse when the device is disconnected from mains. Only use fuses of the same
rating and power. The correct fuse value is specified on the rear panel.
Power input
13
Used to plug in the supplied power cord.
18
Werbung
Inhaltsverzeichnis
