Ocpp 1.6 Json Additional Features; Locked Cable Function (Model With Socket) - VESTEL EVC04 Serie Bedienungsanleitung

2.3 - OCPP 1.6 JSON ADDITIONAL FEATURES

2.3.1 - REMOTE CHARGE INITIATION / TERMINATION
This feature is supported by the charging station. If it is also supported by the connected server,
then charging process may be initiated/terminated remotely.
2.3.2 - HARD RESET/ SOFT RESET
If the electric vehicle charging station is not working properly, the service provider may reset
the appliance with this feature. There are two types of resets: Software or hardware reset may
be selected.
2.3.3 - UNLOCKING THE SOCKET
If the charging cable is locked at the station, the service provider may unlock the cable via this
feature.

LOCKED CABLE FUNCTION (Model with Socket)

The cable becomes locked and your socket model charging station starts behaving as an
attached cable model.
1- Turn off the power of your charging station.
3- To enable locked cable function, toggle DIP switch
pin 3 to ON position using pointed spudger or a
plastic pointed tool. The DIP switch location is as
shown in below figure.
1
IB v7.3.0 2021
Enabled
ON
1 2 3 4 5 6
Disabled
© 2021 Vestel - All rights reserved
2- Open the product cover as described in the
installation manual.
4- Close the product cover as described in the
installation manual.
English - 31