Preparation For Use; Storage Of Food - Veripart VPVR144 Bedienungsanleitung

PREPARATION FOR USE

1. Standing time
After the freezer is properly installed and well cleaned, do not switch
it on immediately. Wait to switch the freezer on only after more than 1
hour of standing time, so as to ensure its normal operation.
2. Cleaning
Check the accessory parts inside the freezer and wipe the inside
with a soft cloth.
3. Power-on
Insert the plug into the solid socket to start the compressor. After 1
hour, open the freezer door, if the temperature inside the freezer
compartment has dropped noticeably, the refrigeration system is
working normally.

4. Storage of food

After the freezer has been running for a period of time, the internal
temperature of the freezer will be automatically controlled according to
the user's chosen temperature setting. After the freezer is fully cooled,
you may load it with food, which usually needs 2~3 hours to cool
completely. In summer, when the outside temperature is high, it takes
more than 4 hours for food to be fully cooled (Try to open the
freezer door as little as possible before the internal temperature
has cooled down).
！ ！
Warning!
• If the freezer is installed in a damp area, make sure to check whether
the ground wire and leakage circuit breaker are normal. If vibration
or noises are produced due to the freezer being in contact with
the wall or if the wall is blackened by air convection around the
compressor, move the freezer away from the wall. Installation of the
freezer may cause static or image distortion on mobile phones, fixed-
line telephones, radio receivers or television sets nearby, so try to
keep the freezer as far away from such devices as possible.
33