Installation - King gates INTROSMALL Installierungs-Und Gebrauchsanleitungen Und Hinweise

2. Description of the product
and destination of use
This product is destined to be used to automate gates or doors
with hinged panels, exclusively in the residential environment.
ATTENTION! – Any use different to that described and in
environmental conditions different to those stated in this
manual must be considered improper and prohibited!
The product is an electro-mechanical gear motor, with a 24 Vdc
motor. The gear motor is powered by the external control unit, to
which it must be connected.
If the electric energy is interrupted (black-out), the gate panels can
be moved by releasing the gear motor using the relevant wrench;
to perform the manual manoeuvre, see chapter 3.6.
ATTENTION! – Do not use gear motors with incompatible
control units.

3. Installation

3.1 - Preliminary checks on
installation
Before performing installation, check the integrity of the product
components, the adequacy of the model chosen and the
suitability of the environment destined for installation.
IMPORTANT – The gear motor cannot automate a manual
gate that does not have an efficient and safe mechanical
structure. Moreover, it cannot solve defects caused by
incorrect installation or bad maintenance of the gate itself.
3.2 - Suitability of the gate to
automate and the surrounding
environment
• Check that the gate mechanical structure is suitable to be
automated and complies with the Standards in force on the
territory (if necessary, refer to the data given on the gate label).
• Moving the gate panel manually in Opening and in Closure,
check that the movement takes place with the same and
constant friction in all points of the run (there must not be
moments of greater effort).
• Check that the gate panel stays in equilibrium, i.e. that is does
not move if taken manually into any position and left.
• Check that the space around the gear motor allows to
manually release the gate panels easily and safely.
• Envision end run retainers on the ground both for opening and
closure of the gate.
• Check that the gear motor fixing area is compatible with the
clearance of the latter (fig. 1).
10
3.3 - Limits of use for the product
Before installing the product, check that the gate panel has
dimensions and weight that lie within the limits given in graph 1;
also evaluate the climatic conditions (e.g. strong wind) present in
the place of installation. They can greatly reduce the values given
in the graph.
400
330
300
250
100
1
3.4 - Set-up for installation
Fig. 2 shows an example of automated plant realised with King
Gates components.
These components are positioned according to the typical and
usual layout.
With reference to fig. 2, establish the approximate position where
each component envisioned in the plant will be installed and the
most appropriate connection layout.
Components useful for realising a complete plant (fig. 2):
A - Electro-mechanical gear motors
B - Control unit
C - Pair of photocells
D - Columns for pairs of photocells (C)
E - Flashing signal with antenna incorporated
F - Digital keyboard
G - Pair of mechanical stops in opening and closure
H - Key selector switch
GRAPH 1
1.5 1.8
2
PANEL MAX LENGTH (m)
2.3