Inhaltsverzeichnis
Werbung
12
GETTING STARTED
On the device are only few of them serviceable components. It is not allowed to
disassemble the machine. Repairs must only be performed by an expert!
Accessories: Use only recommended by your dealer or by ZIPPER Accessories!
If you have any questions or problems, contact our customer service.
12.1
During the initial commissioning
The machine is delivered pre-assembled, you only need to mount the blade and possibly the
retaining bracket.
12.1.1 Fitting the cutting blade
ON OFF Switch to the OFF switch
Press the lock (1) of the blade at a slight rotation of the blade to the spindle.
With the supplied wrench, unscrew the nut (2) from the spindle.
Remove the washer (3) and the outer flange (4).
Place the blade on the spindle renewed. Replace the flange and the right case-washer and
tighten the nut. Tightening torque 22 Nm.
The mother herself is tightening the screw in the direction of rotation.
12.1.2 Protection cover set
Use the rotary knob (1) You can change the position of guard.
Make sure that there is as little dust from the operator of the machine directed.
12.1.3 Adjust V-belt tension:
Remove the screws (1) on the drive housing and remove the belt guard(2).
Loosen the three screws (3) on the belt guide.
Turn the block plug (4) set in the clockwise direction about the optimum
tension of the V-belt.
Tighten the mounting screws (3) firmly.
Attach the belt cover with the screws (1)
Adjust belt tension after 5 minutes of idling. During the first day in operation, you should
frequently check the belt tension. Belts are correctly tensioned when it does not just slip under full
load. Excessive tension reduces the life of the belt.
ZIPPER MASCHINEN GmbH
ZI-BTS350
www.Zipper-Maschinen.at
GETTING STARTED
rotary knob
22
Werbung
Inhaltsverzeichnis
