Refuelling; Engine Start; Cold Start - Zipper Maschinen ZI-BTS350 Betriebsanleitung

12.1.4 Refuelling

The concrete cutting cutter is powered by a gasoline-oil mixture.
For the 2-stroke engine, you need a gasoline-oil mixture with a mixing ratio of 40:1.
When refueling sure that no foreign particles get into the tank.
During refueling the fire, naked flame and smoking prohibited.
Refuel with the engine running or when engine parts are still hot, is
strictly prohibited.
Refuel only outdoors or in well-ventilated areas.
Wipe off spilled fuel immediately.
Fuel is highly flammable!
Use high-quality synthetic oil for heavy-duty two-stroke engines, if you want to make your
mixture itself. Synthetic oil reduces soot and deposits on spark plug in the cylinder, the
piston and the exhaust what the engine lubrication increases, and thus the life of the engine.
Ge self-made mixtures are to consume within 4 weeks.
ZIPPER Maschinen recommends the use of high-quality finished mixtures specifically for
heavy-duty two-stroke engines.
Before each use, shake the tank properly! Otherwise, the risk of damage
to the motor consists of seizures, because it is lubricated at the beginning
too little.
Before each operation:
 Check the tightness of the blade, the fixing nut and all other threaded fasteners.
 Check the fuel level and refill if necessary (fuel mixture ratio 40:1)
13 OPERATION
13.1

Engine Start

Place the concrete release cutter safely on the ground. The blade must not be to the ground or
other objects together.
Before the blade, no persons are allowed to stay there.
NOTE: Remove at least 3m from the refueling.

13.1.1 Cold start:

 Press the ON-OFF switch to the "ON" position
 Adjust the combi-switch (2) the corresponding position.
 At restart the combination switch (2) in to be adjusted to the "Choke"
 On a warm start of the ˝Choke˝ is not used. The combi-switch remains in the
 Press with your hand on the handle above the switch (3) of the throttle lever (4). Then push
the throttle lever (4) up.
 Press with your thumb throttle-lock button (5) and leave at the same time the throttle lever
to the lock button can lock.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BTS350
H I N W E I S
OPERATION
Position.
Position.
23