Overload Protection; Overheat Protection - Makita MP001G Betriebsanleitung

Indicating the remaining battery
capacity
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
► Fig.2: 1. Indicator lamps 2. Check button
Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
Tool / battery protection system
The tool is equipped with a tool/battery protection sys-
tem. This system automatically cuts off the power to
extend tool and battery life. The tool will automatically
stop during operation if the tool or battery is placed
under one of the following conditions:

Overload protection

This protection works when the tool/battery is operated
in a manner that causes it to draw an abnormally high
current. In this situation, turn the tool off and stop the
application that caused the tool to become overloaded.
Then turn the tool on to restart.

Overheat protection

This protection works when the tool/battery is over-
heated. The lamp blinks and the overheat warning icon
is displayed on the pressure gauge. In this situation,
turn the tool off and let the tool and battery cool down.
Then, turn the tool on again.
Overdischarge protection
This protection works when the remaining battery
capacity gets low. In this situation, remove the battery
from the tool and charge the battery.
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
Main power switch
WARNING:
Always turn off the main power
switch when not in use.
CAUTION:
When carrying the tool, turn off the
main power switch. Otherwise, pulling the switch
trigger unintentionally may cause an injury.
► Fig.3: 1. Main power switch
To turn on the tool, press the main power switch. To turn
off the tool, press the main power switch again.
NOTE: This tool employs the auto power-off function.
To avoid unintentional start up, the main power switch
will automatically shut down when the switch trigger
is not pulled for a certain period after the main power
switch is turned on.
Switch action
WARNING:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
WARNING:
Do not attach a tape or such to
keep the switch trigger in the "ON" position.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
► Fig.4: 1. Switch trigger
Pressure gauge
► Fig.5
1
2
3
4
5
6
7
8
9
If the object to be inflated is connected to the tool, the
current pressure value of the object is displayed on the
pressure gauge when you turn on the tool. If nothing is
connected to the tool, the pressure gauge displays "0".
The pressure gauge also displays the target pressure
value, pressure value unit, and inflation mode. They are
the same as the last time.
When you start inflation, the inflation progress indicator
is displayed. The inflation completes when the inflation
progress indicator comes to the right end.
9 ENGLISH
Overheat warning icon
Inflation mode
[-] button
[M] button
[+] button
Inflation progress indicator
Current pressure value
Target pressure value
Pressure value unit