Setting Up - NEFF T18TS2KN-Serie Gebrauchsanleitung

Hood connection
en
Refer to the Home Connect documents supplied and
the Home Connect section for more information.
~ "Home Connect" on page 62
Connecting appliances directly
If the appliance is connected directly to an extractor
hood, the extractor hood can be controlled via the hob.
It is then not possible for either of the appliances to
connect to your home network or to the app. Both
appliances can be controlled via the control panel.
Connecting appliances via your home network
Use this type of connection if neither or one of the two
appliances is connected to the Home Connect app.
If the appliances are connected to each other via your
home network, you can use both the hood controls and
Home Connect to operate the hob.
Notes
Make sure you follow the safety instructions in the
■
instruction manual for your extractor hood and that
these are complied with even when operating the
appliance via the hood controls on the
hob.~ "Important safety information" on page 51
If the appliance is being operated by means of the
■
controls on the extractor hood, this mode of
operation always has priority. It is not possible to use
the hood controls on the hob during this time.
66
In networked standby mode, your appliance requires
■
a maximum of 2 W.

Setting up

Both the hob and the extractor hood must be switched
on before you can connect them to each other.
To do this, refer to the section entitled "Connecting to
the hob" in the instruction manual for your extractor
hood.
Connecting directly
If you connect your hob directly to the extractor hood, it
cannot be connected to your home network as well and
you will not be able to use Home Connect.
Switch on the hob.
1.
Touch and hold the
2.
The product information is displayed.
Touch the symbol repeatedly until the
U
3.
setting appears.
lights up in the hotplate display.
‹
Set the value to ‚ using the twist knob.
4.
flashes in the hotplate display.
‚
You have two minutes to initiate the connection
5.
process on the extractor hood.
Once the hob is connected to the extractor hood, the
value appears in the hotplate display. After you exit
„
the settings menu, the symbols for the hob-based hood
controls are displayed in the hob's control panel.
Connecting via your home network
You require a router that has WPS functionality.
You require access to your router.If you do not have
this, follow the steps for "Direct connection".
When you begin, make sure that the extractor hood is
connected to the app or is on your home network.
Switch on the hob.
1.
Touch the symbol for 4 seconds.
U
2.
The product information will be displayed.
Touch the symbol repeatedly until the
U
3.
setting appears.
(not connected) or
‹
network) will be lit on the hotplate display.
Set the value to using the twist knob.
‚
4.
will flash on the hotplate display.
‚
If the appliance is not yet connected to your home
5.
network, press the WPS button on the router within
the next 2 minutes.
The hob will be connected to your home network
and the value will appear on the hotplate display.
ƒ
The process of connecting to the extractor hood
starts automatically and is active for 2 minutes.
If the appliance is already connected to your home
network, proceed to the next step.
Initiate the process for connecting to the extractor
6.
hood.
Once the connection process is complete, the value
will appear on the hotplate display.The symbols for the
hood controls on the hob are displayed on the hob's
control panel.
symbol for four seconds.
U
™‚‡
™‚‡
(connected to home
ƒ
„