Electrical Connections - AEG MBB1755S Benutzerhandbuch

2_AEG16_EN230_CS_BASE_AL28_Layout 1 30/06/2016 15:16 Page 52
52
www.aeg.com
9.2 Safe use of the appliance
If fitting the microwave in position B or C:
• The cupboard must be a minimum of
500 mm (E) above the worktop and
must not be installed directly above a
hob.
• This appliance has been tested and
approved for use near domestic gas,
electric and induction hobs only.
9.3 Connecting the appliance to
9.4 Electrical connections
The manufacturer declines any liability
should this safety measure not be
observed.
the power supply
(A)
WARNING!
THIS APPLIANCE MUST BE
EARTHED
• Sufficient space between hob and
microwave should be allowed to
prevent overheating of microwave
oven, surrounding cupboard and
accessories.
• Do not operate the hob without pans
when the microwave oven is operating.
• Care should be taken when attending to
the microwave oven while the hob is
on.
• The electrical outlet should be readily
accessible so that the unit can be
unplugged easily in an emergency. Or
it should be possible to isolate the oven
from the supply by incorporating a
switch in the fixed wiring in accordance
with the wiring rules.
• The socket should not be positioned
behind the cupboard.
• The best position is above the
cupboard, see (A).
• Connect the appliance to a single
phase 220-240 V/50 Hz alternating
current via a correctly installed earth
socket. The socket must be fused
with a 10 A fuse.
• The power supply cord may only be
replaced by an electrician.
• Before installing, tie a piece of string to
the power supply cord to facilitate
connection to point (A) when the
appliance is being installed.
• When inserting the appliance into the
high-sided cupboard, DO NOT crush
the power supply cord.
• Do not immerse the power supply cord
or plug in water or any other liquid.
If the plug that is fitted to your appliance is
not suitable for your socket outlet, you
must call your authorised ELECTROLUX
service agent.