Belden Hirschmann OCTOPUS3 Referenzhandbuch Seite 861

Industrieprotokolle
15.3 EtherNet/IP
Tab. 58:
Id Attribute
0x8 Interface state
0x9 Admin State
0xA Interface label
Tab. 59:
Id Attribute
0x64 Ethernet Interface
Index
0x65 Port Control
0x66 Interface Utilization Get
0x67 Interface Utilization
Alarm Upper
Threshold
0x68 Interface Utilization
Alarm Lower
Threshold
0x69 Broadcast limit
0x6A Ethernet Interface
Description
346
Instanz-Attribute (Forts.)
Access
Rule
Get
Set/Get USINT
Get
Hirschmann-Erweiterungen des Ethernet-Link-Objekts
Access
Rule
Get
Get/Set DWORD
Get/Set USINT
Get/Set USINT
Get/Set USINT
Get/Set STRING
Data type Description
USINT Current state of the interface:
0: Unknown interface state
1: The interface is enabled
2: The interface is disabled
3: The interface is testing
Administrative state:
1: Enable the interface
2: Disable the interface
SHORT-STRING Human readable ID
Data type Description
USINT Interface/Port Index (ifIndex out of
MIBII)
0:
1:
8:
9:
USINT The existing Counter out of the private
MIB hm2IDiagfaceUtilization is used.
Utilization in percentage (Unit 1%=100,
%/100). RX Interface Utilization.
Within this parameter the variable
hm2DiagIfaceUtilizationAlarmUpperTh
reshold can be accessed. Utilization in
percentage (Unit 1%=100).
RX Interface Utilization Upper Limit.
Within this parameter the variable
hm2DiagIfaceUtilizationAlarmLowerTh
reshold can be accessed. Utilization in
percentage (Unit 1%=100). RX
Interface Utilization Lower Limit.
Broadcast limiter Service
(Egress BC-Frames limitation,
0=disabled), Frames/second
Interface/Port Description
(from MIB II ifDescr), for example
"Unit: 1 Slot: 2 Port: 1 - 10/100 Mbit TX"
or
"unavailable", max. 64 Bytes.
Link state
(0=link down, 1=link up)
Link admin state
(0=disabled, 1=enabled)
Access violation alarm (read-only)
Utilization alarm (read-only)
UM Config OCTOPUS3
Release 8.7.02 07/2021