Inhaltsverzeichnis
Werbung
12
SYSTEM 55
Modules
Your System 55 has three rows of modules
(1)
(2) (3) (4) (5) (6) (7) (8) (9) (10) (11) (12) (13) (14) (15)
Top Row
(1) 914 Fixed Filter Bank (FFB).
(2) 923 Filters and Noise Sources.
(3) 904B High Pass Filter (HPF).
904A Low Pass Filter (LPF).
(4)
(5) 992 Control Voltages.
(6) & (7) /
-
902 Voltage Controlled Amplifiers (VCA).
(10)
(12)
(8) & (9) /
&
911 Envelope Generators (EG).
(14)
(15)
911A Dual Trigger Delay (DTD).
(13)
Middle Row
(1) (2) (3) (4) (5) (6) (7) (8)
(1) & (5)
921A Oscillator Driver.
(2) - (4) / (6) - (8)
921B Voltage Controlled Oscillators (VCO).
(9) 921 VCO/LFO.
960 Sequential Controller.
(10)
CM1A – MIDI interface.
(11)
(9)
(10)
Bottom Row
(1)
(2)
(3) (4)
(1) / (4) / (7) CP3A – O.
(2) / (5) / (8) CP3A – M.
(3) & (6) 995 Attenuators.
(9) 903A Random Signal Generator.
CP35 Attenuator / Voltage Source / Multiple.
(10)
961 Interface.
(11)
962 Sequential Switch.
(12)
Further information on all modules can be found on their individual Quick Start Guides at www.behringer.com/downloads.html
System 55 - Getting Started
HARDWARE SETUP
Make all the connections in your system as described in the individual patches. Keep the System 55 power turned off when making any connections.
Ensure your sound system is turned down.
Turn on the System 55 before turning on any power amplifiers and turn it off last. This will help prevent any turn on or turn off "pops or thumps" in your speakers.
WARM UP TIME
We recommend leaving 30 minutes or more time for the System 55 to warm up before recording or live performance. (Longer if it has been brought in from the cold.)
This will allow the precision circuits time to reach their normal operating temperature and tuned performance.
(11)
(5)
(6) (7)
(8) (9)
(10)
13
Quick Start Guide
(11)
(12)
Werbung
Inhaltsverzeichnis
