Cleaning The Heat Exchanger - Electrolux TWGL5E Benutzerhandbuch

2. Move the plastic connection out and
drain the water into a basin or
equivalent receptacle.
3. Move plastic connection in and install
water container.
4. To continue the programme press the
Start/Pause button.
11.3 Cleaning the heat
exchanger
If the indicator Heat exchanger
(Kondensator) flashes, do the inspection
of the heat exchanger and its
compartment. If there is a dirt, clean it.
To do the inspection:
1. Open the door. Pull the filter.
2. Move the release button on the
bottom of the door to open the heat
exchanger door.
3. Turn the blockage to unlock the heat
exchanger cover.
4. Lower the heat exchanger cover.
5. If necessary, remove the fluff from the
heat exchanger and its compartment.
You can use wet cloth and/or a
vacuum cleaner with the brush.
ENGLISH 19