Cleaning The Heat Exchanger - Electrolux TW SL6 E Benutzerinformation

22 www.electrolux.com
4. If necessary clean the filter with the
brush under warm tap water and/or a
vacuum cleaner. Close the filter.
5. If necessary remove fluff from the filter
socket and gasket. You can use a
vacuum cleaner. Put the filter inside
the filter socket.
11.2 Draining the water
container
Drain the condensed water container after
each drying cycle.
If the condensed water container is full,
the programme breaks off automatically.
The symbol
Water container (Behälter)
is on the display and you must drain the
water container.
To drain the water container:
1. Pull the water container and keep it in
horizontal position.
2. Move the plastic connection out and
drain the water into a basin or
equivalent receptacle.
3. Move plastic connection in and install
water container.
4. To continue the programme press the
Start/Pause button.
11.3 Cleaning the heat
exchanger
If the symbol Heat exchanger
(Kondensator) flashes on the display, do
the inspection of the heat exchanger and
its compartment. If there is a dirt, clean it.