Inhaltsverzeichnis
Werbung
2
6
INSTALLATION INSTRUCTIONS
INSTALLATION OF THE WALL HANGER
4
3
1
INSTALLATION OF THE HOOD
7
6
5
• Trace a vertical line on the wall to indicate the
centre of the cooker plate.
• Place the hood body
mm from the cooker plate (see p. 12). Level it
horizontally. Use the top of the rear side of the
hood as ruler to trace the line.
• Hold a hood hanger profile
horizontally, symmetrically to the central line,
mark the mounting holes on the wall.
• Drill the holes as indicated on the wall, using drills
of diameter 8 mm, drive the plugs in and then
screw the hanger profile to the wall. The hooks
should be upward oriented.
•
Hang the hood body on the installed hanger
• If the cooker hood will be use in extractor mode it is
necessary to mount a vent conduit of Ø 150 mm
on the fixed V-flap . By connection of a conduit of
3
Ø 120 mm use an adapter .
•
I
f the cooker hood will be operate in odour
absorber mode it is necessary to install charcoal
filter ( see p. 24).
•
Attach the telescopi column
cover
5
of
the mounted hood
• P
ull out the
masking cover
height. Mark the level of the mounting holes.
Remove the masking cover.
• Place
the hanger of the top masking cover
the level of mounting holes and install the hanger
• Hang
the masking cover column
body and to
the
wall
screws.
EN
1
on the wall to get min 650
2
to the wall on the
1
4
c
6
on
the masking
1
.
6
on the demanded
6
to the hood's
hanger using appropriate
2
.
7
at
.
Werbung
Inhaltsverzeichnis
