Philips Lumea SC2002 Bedienungsanleitung Seite 27

Problem Possible cause
The wall socket is
not live.
The adapter is not
inserted properly
into the wall
socket and/or the
small plug is not
inserted properly
into the appliance
socket.
The appliance is
defective.
I have switched on the The appliance has
appliance but I cannot to be reset.
increase or decrease the
light intensity.
The 'ready to flash' light You have not put
does not go on when I the attachment
place the appliance on with safety ring
the skin. properly on the
skin.
The safety ring is
dirty.
The 'ready to flash' light The overheat
does not go on when I protection has
place an attachment on been activated.
my skin, but the cooling
fan works.
All manuals and user guides at all-guides.com
Solution
Connect another appliance to the wall socket to check
if the wall socket is live. If the socket is live but the
appliance still does not charge, contact the Consumer
Care Centre in your country, your Philips dealer or a
Philips service centre.
Make sure the adapter is inserted properly into the
wall socket and/or the small plug is inserted properly
into the appliance socket.
Contact the Consumer Care Centre in your country,
your Philips dealer or a Philips service centre.
To reset the appliance, switch off the appliance and
then switch it on again. If you still cannot adjust the light
intensity, contact the Consumer Care Centre in your
country, your Philips dealer or a Philips service centre.
Place the appliance in a 90° angle onto the skin in such
a way that all contact switches touch the skin. Then
check if the 'ready to flash' light is on and press the
flash button.
If this does not work, place the appliance on a part
of your body where it is easy to establish full skin
contact, for example on your lower arm.Then check
if the 'ready to flash' light works. If the 'ready to flash'
light still does not go on when you place the appliance
on the skin, contact the Consumer Care Centre in your
country, your Philips dealer or a Philips service centre.
Clean the safety ring carefully. If you are unable to clean
the safety ring properly, contact the Consumer Care
Centre in your country, your Philips dealer or a Philips
service centre to replace the attachment.
When the overheat protection has been activated, the
fan still works. Do not switch off the appliance and let it
cool down for approx. 15 minutes before you continue
to use it. If the 'ready to flash' light still does not go on
when you place the appliance on the skin, contact the
Consumer Care Centre in your country, your Philips
dealer or a Philips service centre.
EngliSh
27