Beginning Work; Stair Transportation; End Of Operation; Service, Maintenance And Care - diversey TASKI ergodisc HD Bedienungsanleitung

Beginning work

Caution:
For beginners, we recommend practising handling the machine
on a flat surface in a wide open area until you are used to handling
the machine.
• Connect the power supply cord to the mains
socket.
The indicators light up.
• Lead the power supply cord with your hand.
Make sure that the power supply cord does not touch the tool.
• Hold on to the machine.
• Push the safety switch and press the operating
lever at the same time.
By doing this the tool is activated.
By slightly lifting the guide bar the machine moves to the right and
by lowering it the machine moves to the left.

Stair transportation

At least 2 people are necessary for stair transportation.
• Release the operation lever.
• Disconnect the power supply cord from the mains socket.
• Turn the tool away from the coupler.
Caution:
Due to the weight of the machine, there are risks involved in such
transportation!
Injuries to persons or damage to the machine could result from
trips.
• When lifting, one person should hold the
machine at the brush cover, and the second
person at the machine handle.

End of operation

• Release the operation lever.
• Pull the power supply cord out of the mains socket.
• Tilt the machine back slightly.
• Turn the tool away from the coupler.
• Carefully lower the machine onto the tool unit.
24
• Pull the height adjustment lever and slowly lift
the guide bar until it is in the upright position.
• Let go of the height adjustment lever, the guide
bar will locate into place and stay at that angle.
• Clean the power supply cord with a damp cloth
and wrap it around the machine handle and the
cord hook.
Emptying solution
The disposal of solution must be carried out in accordance with the national
regulations.
• Remove the water tank from the machine and empty it.
Cleaning the tool
• Clean the tool under running water with a brush.
• Rinse out the water pipe and the nozzle thoroughly with water.
If the cleaning solution dries up, it could cause malfunctions.
Cleaning the pad
• Lay the pad into cleaning solution for a few hours and then rinse it off.
The pads may be put into the washing machine and washed at a max. of
40°C.
• Air dry the pads.
Caution:
Do not tumble dry the pads!
Cleaning the machine
Caution:
Never clean the machine with high water pressure or a water
hose.
The ingress of water into the machine might cause considerable
damage to mechanical or electrical parts.
• Wipe down the machine with a damp cloth.
Storing the machine
Caution:
Never store the machine with a mounted tool!
The tool may get damaged and become unusable.

Service, maintenance and care

The correct maintenance of the machine is a precondition for error-free
operation and a long service life.
Caution:
Always unplug the mains plug from the main socket when carrying
out any maintenance work!
Caution:
Only TASKI branded spare parts must be used, otherwise
warranties and liabilities will be omitted!