Pioneer AVIC-HD1BT Installationsanleitung Seite 7

• Never connect speakers with an output rating of less than 50 W channel or impedance
outside of the 4 ohms to 8 ohms specifications to your navigation system. Connecting
speakers with output and/or impedance values other than those noted here may result in
the speakers catching fire, emitting smoke, or becoming damaged.
• When the ignition switch is turned on (ACC ON), a control signal is output through the
blue/white lead. Connect to an external power amp's system remote control terminal
(max. 300 mA 12 V DC). The control signal is output through the blue/white lead, even
if the audio source is switched off.
• When an external power amp is being used with this system, be sure not to connect the
blue lead to the amp's power terminal. Likewise, do not connect the blue lead to the
power terminal of the auto aerial. Such connection could cause excessive current drain
and malfunction as well as damage to the auto aerial of the vehicle.
Parts supplied
The navigation unit
Extension lead
(for reverse signal)
RCA connector 1
(CONNECTOR 1)
< See Page 10, 13, 16>
Power cord
< See Page 9, 11, 15>
Extension lead
(for speed signal)
RCA connector 2
(CONNECTOR 2)
< See Page 7, 12, 15, 17>
Connector
GPS aerial
Microphone
6