OUT SYSTEM Technisches Handbuch Seite 38

DATASHEET
DESCRIPTION
The protective coating 03WET is achieved by applying two different products: first the two-part product 03WET_
A+B, then the single-part product 03WET_C.
To achieve the full finish of 03WET, apply two coats of 03WET_A+B, leave it to dry, then apply a coat of 03WET_C.
The single-part product 03WET_C is a polyurethane based, moist curing, alyphatic, solvent free coating, highly
resistant to yellowing. 03WET_C gives the surface to be coated a see-through, highly opaque and scratch
resistant finish that adheres well to the substrate.
RANGE OF APPLICATIONS
03WET_C is therefore suitable as a second finishing and protective coating for OUT SYSTEM 03WET for damp
indoor environments.
SPECIAL CAUTIONS AND INSTRUCTIONS
- do not apply at temperatures lower than 10°C;
- during its application and in the next three days, relative humidity must be between 40 and 50%;
- always close the pot of 03WET_C after each use;
- make sure the application environment is free from dust: the build-up of dust on 03WET_C during and after
application can cause superficial defects;
- do not transfer any left over product from one pot to another;
- do not reuse tools used to apply the product;
- carefully read the Safety datasheet before use.
APPLICATION
Substrate Preparation: make sure that the previously applied 03WET_A+B is completely dry and free from dust.
Product Preparation and Application: shake well the pot of 03WET_C before opening it.
The product is applied with a short hair paint roller.
Before applying, pour small quantities of product at a time in a clean container and wet the roller well. Apply a
uniform coat of product according to the quantities shown below.
The paint roller must be changed after 30 minutes of use.
QUANTITIES USED
The quantity of 03WET_C to be used is about 100-110 g/m
FEATURES
Bulk specific gravitya*, UNI 8310
Viscosity (Brookfield, spindle 2, 50 RPM, 23°C, 50% RH)*, UNI EN ISO 2555
Minimum time of usability ( (16°C; 50% RH)
Minimum crosslinking temperature
Resistance to abrasion (Taber), wheels CS 17, 1000 g, 1000*, DIN 53109
Hardness to scratches*, ISO 1518
Superficial brightness (gloss 60°)*, UNI EN ISO 2813
Packaging
Storage
.
2
1,12 ± 0,03 g/cm
3
65 ± 5 mPas
36-48 hours
10° C
31,2 ± 0,5 mg
5,0 ± 0,5 N
< 20
1 Kg tin
6 months in original packaging, in a sheltered and dry place, at a
temperature between +7°C and +35°C