OUT SYSTEM Technisches Handbuch Seite 29

FINISHES
FINISH FOR DAMP ENVIRONMENTS 03WET
The finish 03WET is suitable as a protective
coating for the OUT SYSTEM applied on damp
environment walls. The finishing cycle 03WET
consists of two coats of parts 03WET_A+B,
previously mixed, and by a coat of part
03WET_C.
During its application, 03WET and, in the next
three days, the air relative humidity must be
between 40 and 50%, the air temperature at
least 10 °C.
To apply OUT SYSTEM 03 WET use a short hair
25cm paint roller. After 30 minutes of usage, the
paint roller must be replaced.
Always close the 03 WET packages after
each use and do not transfer any product left
from one package to another. When the OUT
SYSTEM 02 is completely dry, remove the dust
from the wall using an antistatic cloth. The
application environment must be free of dust.
Shake the packages of 03 WET_A+B before
opening them. Mix well the two parts A and
Buntil smooth.
Always close the packages after each use.
Pour a small amount of product at a time in
a clean basin and wet the roller well before
starting the application.
Apply the product until smooth, ensuring that
the quantity used is 90-110 g/m
2
Two coats of product 03WET_A+B must
be applied, at an interval of 6-8 hours, with
temperatures between +10° and +30°. The time
required to dry 03WET_A+B is 24 hours.
After this time, a coat of 03WET_C can be
applied.
Shake the package well, pour a small amount
of product in a clean basin and apply the
product by using a short hair 25cm paint roller.
As 03WET_C is moist curing, the drying times
depend on weather and humidity conditions:
normally, full drying occurs after 48-72 hours.
After this time, the environments treated are
fully usable.
Carefully read the datasheet before starting the
application.
.
08/09
OUT SYSTEM01
OUT SYSTEM02
OUT SYSTEM03
OUTDOOR
OUT SYSTEM03
WET