OUT SYSTEM Technisches Handbuch Seite 33

DESCRIPTION
OUT SYSTEM02 is a fibreglass fabric used for coating and decorating outdoor surfaces or damp indoor surfaces,
which allows a continuous and smooth finish of the surfaces treated to be achieved.
OUT SYSTEM02 is made with special yarns of very fine fibres, melted at high temperatures. The product maintains
the chemical and physical features of the glass and offers a high mechanical resistance to knocks, tears, fissures
and settlement cracks, thus strengthening the wall.
OUT SYSTEM02 is not toxic, easy to wash and fire-retardant (class 1 and class 0 fire-retardant certification in
process). The reduced static electricity of the fibreglass avoids the build-up of dust.
RANGE OF APPLICATIONS
OUT SYSTEM02 s suitable for environments like bathrooms and fitness areas and is applied not only on walls,
but also on doors, panels and screens. It is suitable for any substrate: cement, plasterboard, wood, plaster, tiles,
uneven or slightly cracked surfaces, even in old buildings.
SPECIAL CAUTIONS AND INSTRUCTIONS
- the application of OUT SYSTEM02 does not require special tools;
- read the Safety datasheet before use.
APPLICATION
Substrate preparation: the surfaces must be dry, clean and stable.
Bonding: prepare the fabric sheets, taking into account that they overhang the wall by 5-10cm.
Apply a uniform coat of OUT SYSTEM01 adhesive with a roller (see the directions on how to use OUT SYSTEM01)
and apply the internal side of OUT SYSTEM02 onto the wall, moving the sheets close to each other, and ensuring
the continuity of the pattern between sheets. If a sheet is not applied perfectly, remove it and reposition it.
After making sure the sheet is applied correctly, press with a plastic spatula from the centre towards the edges
to remove any air bubbles and ensure a perfect adhesion. Remove any surplus adhesive with a water soaked
sponge. Finally, when the fabric is dry, trim the excess fabric with a cutter.
Finish: on the dry fabric OUT SYSTEM02 use the protective coating OUT SYSTEM03, available in two versions
according to its intended use: for outdoor, apply 03OUTDOOR_A+B, for damp environments, apply 03WET_A+B
and finally 03WET_C (see directions for OUT SYSTEM03, 03WET_A+B and 03WET_C).
QUANTITIES USED
To correctly position the fabric sheets, they must overhang by about 5-10cm in relation to the height of the wall
the are applied to.
FEATURES
No. of threads (UNI EN 1049-2)
Weight (ISO 3374)
Resistance to traction (ISO 4606)
Ultimate strength (average value)
Packaging
Warp 81 ± 1/dm
Weft 50 ± 1/dm
275 g/m ± 15%
2
Warp 2300 N/5 cm
Weft 1550 N/5 cm
Fabric width: 940mm; roll length: 3m and 4m according to the pattern.
12/13