General Safety Instructions; Installation And Commissioning - Swim & Fun 1924 Bedienungsanleitung

faecal matter must not be pumped. Any use considered improper or inpredictable damage
can occur as a result of improper use, modifications to the appliance or due to the use of
parts which have not been tested and approved by the manufacturer!
3.

General safety instructions

• To operate this appliance safely, the user must have read and understood these in
structions for use before using the appliance for the first time.
• Always keep the operating instructions within reach.
• If you sell or pass the appliance on, you must also hand over these operating instructi
ons.
• Observe all safety instructions! Failure to do so may cause harm to you and others.
• Do not use the appliance in potentially explosive areas or in the vicinity of flammable
liquids or gases!
• Do not touch the mains plug with wet hands! Always disconnect the mains plug by
pulling the plug and not the cable.
• The connection must be made to earthed sockets which have been properly installed,
earthed and tested. Mains voltage and fuse must comply with the technical data.
• During operation for swimming pools, garden ponds and similar places, the appliance
must be equipped with a residual current circuit breaker (RCCB) with a design fault
current no more than 30 mA.
• Do not kink, crush, drag or drive over the mains cable; protect against sharp edges, oil
and heat.
• Extension cables must not be used.
• Disconnect the mains plug before all work on the appliance.
• Do not install and switch on the appliance if there are people or animals in the medium
being pumped (e. g. a swimming pool), or they are in contact with it.
• Children and young people under the age of 16 years must not use this appliance, and
must be kept away from it when it is in operation.
• Repairs must be carried out only by a qualified electrician.
If repairs are carried out incorrectly, there is a danger of liquid penetrating into the
electrical components of the appliance..
4.

Installation and commissioning

Attach a sufficiently long and strong rope to the specially designed bottom plate position
before first use when the pump is placed onto the pool cover or attach a sufficient long
and strong rope to the handle before first use when the pump needs to be submerged
into the water container as submersible pump.
MV-1924-11-2019 . swim-fun.com © All rights reserved Swim & Fun Scandinavia ApS
UK
31