Assembly Instructions - Viessmann Vitosol-F XL Montage- Und Serviceanleitung

30° 45° 60°
General and transport instructions
standards and regulations. We recommend using an assembly crane for transporting the collector. The collector
must only be lifted via the pre-mounted lifting rings and must not be lifted at the connections. Avoid impacts and
tions.
static load-bearing capacity of the roof or substructure must be checked in accordance with local and regional sti-
to enable the durability of the screw connections for attaching the panel mounting apparatus. The onsite checking
are used for residential purposes and roof pitches that are below the minimum recommended value require (in
relation to the cladding) additional measures to be carried out by the customer in order to protect against the pe-
that it is not possible for excess loads to fall onto the panel system from the higher level as a result of drifting or
ge to the roof cladding.
Structural data for concrete ballasts
over. The minimum weight of the concrete ballasts in relation to the potential gust speed can be found in the
following table. Each supporting plane requires one continuous piece of concrete ballast with a minimum length.
Slip-resistant rubber matting must be placed between the concrete ballast and the installation surface. Due to the
load-bearing capacity of the roof and its suitability to handle possible additional weight (e.g. snow).
30°
45°
60°
Important note regarding the structural design
larger for the roof construction (primary construction). This serves to take into consideration the potential obst-
ruction to snow blow-off from roofs compared to snow loads on the ground.
kN/m²
km/h
4 150
4 137
4 112
EN
Montagehinweise

Assembly instructions

Istruzioni di montaggio
Instructions de montage
Instrucciones de montaje
mm
600x800x3000
-
kg
3600
-
11