Securepoint UTM Security Systems Installationsanleitung Seite 37

Step 6.1:
Enter the IP address, the network mask, the SSID and the pre-shared key as
well as the security mode for the gateway's WLAN interface. Here, too, it is
possible to activate the DHCP service for the WLAN network. In addition, you
can activate the standard port filter rules for the WLAN network using the
second slider. If you want to create the wireless network later, you can skip this
step.
Step 6.2: with bridge
If you have enabled the bridge mode for the internal network or the DMZ
network, you only have to enter the SSID, the security mode and the pre-shared
key.
- 36 -