Factory Settings - Securepoint UTM Security Systems Installationsanleitung

2 Factory Settings

You can access the Securepoint appliance with your web browser via the IP
address of the internal LAN 2 interface on port 11115 using the HTTPS (SSL)
protocol. This IP address is factory set to 192.168.175.1.
Open the web interface of the Securepoint Appliance:
https://192.168.175.1:11115
Note:
Use a current browser to administer the NextGen UTM or the VPN gateway.
You should use a PC with at least a Pentium 4 processor, 1.8 GHz or higher,
and 512 MB or more memory for the web interface.
Reset to factory setting:
In the Web interface of the system, you can reset the appliance to the factory
settings. In the Configuration menu, click Factory Settings. The existing
configuration is overwritten.
The second option to reset the appliance to the factory setting is the new
installation using the Securepoint ISO image or with USB image via stick. You
will find the image in our Reseller Portal and a how-to in our Securepoint Wiki.
Please always use the latest Securepoint UTM version for this variant.
The third variant is via the CLI (Command Line Interface). Please note that
there is no security query here and all other configurations no longer exist after
a restart.
All variants are also available in our Wiki.
Reseller Portal
https://my.securepoint.de
Securepoint Wiki
http://wiki.securepoint.de
- 28 -