Bosch Rexroth WB 2 Montageanleitung Seite 22

8/14
Bosch Rexroth AG, MIT: LU 2/LS, 3 842 562 440/2020-09
• The input is executed with the supply voltage disconnected. The power supply
for the electronics comes from an integrated backup battery.
• The LC 2/LS grease cartridge must be installed on the drive before setting
(see page 11).
In the as delivered condition the display is on the left.
562 440-06
1. Press and hold the SET button (> 5 s), until the modes TIME and IMPULSE
fl ash in the display.
2. Press 2x the SET button.
562 440-07
The display switches to the IMPULSE mode (IMPULSE fl ashes).
562 440-08
After approx. 3 seconds, the display switches to the selection of the grease
cartridge.
3. Press the SET button 1x
Press the SET button 2x
562 440-09
Press the SET button 3x
In the display, the selected grease cartridge fl ashes (here LC120).
562 440-10
After approx. 3 seconds, the display switches to the entry of the metered
lubricant delivery volume.
562 440-11
4. To enter the delivery volume per impulse press the SET repeatedly. The delivery
volume of 0.1
steps.
The delivery volume entered per impulse fl ashes in the display.
Approximately 3 seconds after the entry (inactive SET button) the setting mode
562 440-12
for the delivery volume is terminated.
The operating mode, the quantity of remaining impulses, the entered grease
cartridge LC 2 ( LC120) and the metered volume to be delivered per pulse are
shown on the display.
If the number of remaining impulses is 100 or greater, the following indicator
appears in the display
562 440-13
5. Turn on the power to the lubrication unit.
The display shows the plug symbol, and the arrow symbol  flashes in the
display. The drive LEDs flash green at 5 s intervals.
562 440-14

LC60

LC120 (= LC 2/LS)

LC250
... 9.5 cm³/impulse can be scrolled through in the pre-entered
>
99 .