em-tec SonoTT Ultrasonic FlowComputer Bedienungsanleitung Seite 77

SonoTT Ultrasonic FlowComputer
TM
Messages which refer to the Calibration Mode
Messages which refer to the Ultrasonic Coupling
Messages which refer to the Flow Sensors
Copyright em-tec GmbH
• Warning – the calibration mode is activated
• Warning – the acoustic coupling alarm is deactivated
• Warning – the ultrasonic coupling is very low (coupling < 60 %)
• Warning - the ultrasonic coupling is insufficient (coupling < 50 %)
• An illegal sensor is connected
• Two sensors are connected to one flow measurement system
• No sensor is attached
D108-702 SonoTT Ultrasonic FlowComputer - Operating Instructions V4.0
TM
EN
• Page 77