Connection - Xoro HRS 8600 CI Bedienungsanleitung

Connecting to the dish and TV
General information
•
Assure that the device is switched off and unplugged.
•
Read the manual of your TV and attend to the safety instructions.
•
Please establish an accurate connection.
•
Please check the video output settings.
The schematic picture shows the connection of the HRS 8600 CI to the satellite dish and the TV.
Installation Guide
1. Connect a SCART or HDMI cable to the DVB-S receiver.
2. Connect the aerial cable to the aerial input (LNB IN) of the HRS 8600 CI. Screw the plug to
the input.
3. Connect the SCART or HDMI cable to the TV set.
3. Plug the power cable to the wall outlet.
4. Switch on your DVB-S receiver and the TV set.
5. Choose the correct input (SCART or HDMI) at your TV.
Notes:
1. By using the loop through connector you can connect for example a second DVB-S Receiver.
2. You can connect the receiver as well by Video Composite cable (CVBS) to the TV set.
3. You can connect the receiver as well by Video Component cable (YPbPr) to the TV set.
14

Connection

HRS 8600 CI