Product Description; Control Panel Layout - Concept CA2010 Bedienungsanleitung

EN

PRODUCT DESCRIPTION

1. Air outlet
2. Aroma oil container
3. Air inlet
4. LED indicator
4
5. Filter cover
5

CONTROL PANEL LAYOUT

A. Starting button
B. Speed control
C. Ionizer On
D. UV sterilizer On
E. Air quality indicator
F. Sleep mode
G. Timer
H. Child lock
I. Automatic mode
J. A
Speed indicator
K. Filter replacement indicator
L. Lighting sensor
66
1
2
3
J K L
B. C D E F G H I
OPERATING INSTRUCTIONS
INSTALLING THE FILTER
1. Remove the filter cover.
2. Remove the filters from the appliance body and remove the
packaging material.
3. Insert the filters into the appliance in the order shown in the
picture.
4. Place the HEPA filter into the appliance body.
5. Place the carbon filter into the appliance body.
6. Place the pre-filter inside and click the filter cover back into its
place. (The appliance will not work correctly if the filter cover is
not positioned correctly.)
FILTER MAINTENANCE
Pre-filter: To remove dust from the filter surface, use a vacuum cleaner or wash it with water and dry thoroughly.
HEPA + carbon filter: Clean the filters every 2 months. Use the vacuum cleaner to remove dust from both filter
surfaces. Leave the filters in a well-ventilated place. Do not expose the filters to direct sunlight. Do not wash the filters
with water. Replace the filter every six months or when the 1500 hour filter change prompt flashes, and reset the filter
change timer by holding the "Child lock" button.
• Disconnect the mains supply before cleaning and maintenance.
• Do not operate the appliance with the filter removed (operation without the effect of removing dust may cause
the appliance to malfunction).
• If the appliance is idle for a long time, unplug the power cord (it also consumes power in standby mode).
CONTROL
When connected to the mains, the device enters the standby mode. After pressing the "Power" button,
the device turns on in automatic mode. If you press the "Power" button again, the device will switch
to the standby mode.
After pressing the "Child Lock" button, the button lights up and blocks functions of all the other
buttons. Press the button and hold it for 3 seconds to activate this mode. While holding down the
"Child Lock" button for 5 seconds, the display will show the time of the filter use.
Press the "Anion" button to activate the ionizer function, the button lights up. Press it again to turn
the ionizer off.
CA2010 CA2010
EN
1. HEPA filter
2. Carbon filter
3. Pre-filter
67