Toro Recycler 21770 Bedienungsanleitung Seite 17

WARNING
Folding or unfolding the handle improperly can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or unfolding the handle.
• If a cable is damaged, contact an Authorized Service Dealer.
1. Ensure that the level of fuel in the fuel tank is no higher than what is recommended by the engine
manufacturer; refer to the engine manufacturer's decal on the engine
Note:
If there is the level of fuel in the fuel tank is too high, drain the fuel from the fuel tank into an
approved fuel container until it is at or below the level recommended by the engine manufacturer.
2. Ensure that the cutting-height setting on the machine is 92 mm (3-5/8 inches) or lower. If it is not, lower
it; refer to Adjusting the Cutting Height (page
3. Disengage the handle locks (A of
4. Fold the handle fully forward (B of
Important:
Route the cables to the outside of the handle knobs as you fold the handle.
5. Engage the handle locks (C of
6. Lift the front of the machine by the handle and move it into a storage space
Figure 17
9).
Figure 18).
Figure 18).
Figure 18).
Figure 18
Figure 19
15
(Figure 17).
(Figure 19).
decal133-8198
g356894
g356895