Installation - Samoa 391020.270 Anleitung

INSTALLATION

WARNING: If the unit is not installed correctly this can result in
!
serious injury or material damage. Read the warnings.
(See warnings and precautions).
Secure firmly the base to the concrete floor using anchor bolts
(not included in the supply).
Once the definitive location of the unit has been defined, pay special
attention to the work area that will be above the inductor; this work
area shall be free of objects and any electrical devices. Once you have
finished the above step, secure the unit definitively. The lift bose and
plate bose itself can be used as a pattern to establish the correct fixing
locations (fig. 2).
To extend the life of the unit and the pump, use a filter at the control
panel input.
Fig. 2
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
1. For models (391020, 391020.270, 391023, 391021):
Place the pump support and screw the bolts (1) (fig. 3).
2. If the pump includes the follower plate (754205) (fig. 4). Apply PTFE
tape on inlet pump thread and screw into follower plate.
If the pump includes the follower plate (841414) (fig. 5). Fix the
pump (4) to follower plate (5) with grub screw (6).
3. Only for model 391022. Fix the pump through eye bolt with bolt
and nut (7) (fig. 6).
4. To other models fix the pump on the mounting plate with three hex
bolts (7) (fig. 7). Screw the connector (8) into airmotor inlet and
connect the 12 mm tube (9). For model with follower plate,
connect the 6 mm tube to non-return valve (10) (fig. 4). Only for
pumps (542010, 542011, 543010, 543011, 544010) fit the male/
female swivel (11) (fig. 9).
5. If the elevator includes the base plate, screw the drum stops on it
(12) (fig. 10).
1
Fig. 3
Fig. 5
5
2
10
4
6
R. 09/20 854 807
EN
Fig. 4
3
3