Hose Connections - COMFORTPOOL PRIME Sicherheitshinweise

▪
Now place the centralizer on the tank opening while centering the standpipe.
▪
Fill the filter to approximately three quarters of the tank with filter sand (coarse sand, grain size 0.4 - 0.8
mm), glass filter media or filter balls. The amount depends on the filter size.
▪
Attach the top of the tank or the valve head and the seal to the top of the tank. Before you do this, it is
necessary that you wash and clean off all sand and accumulated debris. The connection of the top of the
tank or valve head to the filter tank is secured using clamp rings. The clamping ring is screwed on with the
clamping screw and clamping nut.
▪
Finally, mount the pump fittings on the valve head. Seal the pump fittings by using Teflon tape.
▪
The pressure gauge (if included) is screwed to the side of the 7-way valve and sealed. The existing vent
plug should be removed first.
2.3.

Hose connections

▪
Skimmer: connection form the skimmer to the front connector of the filter pump.
|
NL
19