Pioneer SPH-T20BT Benutzerhandbuch Seite 16

CAUTION
It is extremely dangerous to allow
the microphone lead to become
wound around the steering column
or shift lever. Be sure to install the
microphone in such a way that
it will not obstruct driving. It is
recommended to use the clamps
(sold separately) to arrange the
lead.
NOTE
Depending on the vehicle model,
the microphone cable length may
be too short when you mount the
microphone on the sun visor. In
such cases, install the microphone
on the steering column.
To install on the sun
visor
1
Fit the microphone lead into
the groove.
Microphone lead
Groove
2
Install the microphone clip
on the sun visor.
Lowering the sun visor reduces
the voice recognition rate.
16
En
Microphone clip
To install on the
steering column
1
Slide the microphone
base to detach it from the
microphone clip.
Microphone
Microphone clip
Microphone base
2
Install the microphone on
the rear side of the steering
column.
Double-sided tape
Copyright and
trademark
Bluetooth
The Bluetooth® word mark and
logos are registered trademarks
owned by Bluetooth SIG, Inc. and
any use of such marks by PIONEER
CORPORATION is under license.
Other trademarks and trade names
are those of their respective owners.
T-Kernel 2.0
This product uses the source code
of T-Kernel 2.0 under T-License 2.0
granted by T-Engine Forum (www.
tron.org).
Specifications
General
Power source: 14.4 V DC (10.8 V to
15.1 V allowable)
Grounding system: Negative type
Maximum current consumption:
10.0 A
Dimensions (W × H × D):
DIN
Chassis: 178 mm × 100 mm ×
165 mm
Nose: 188 mm × 125 mm ×
33 mm
D
Chassis: 178 mm × 100 mm ×
165 mm
Nose: 171 mm × 125 mm ×
25 mm
Weight: 1.2 kg
Audio
Maximum power output:
• 50 W × 4 ch/4 Ω (for no
subwoofer)
• 50 W × 2 ch/4 Ω + 70 W × 1 ch/
2 Ω (for subwoofer)
Continuous power output:
22 W × 4 (50 Hz to 15 000 Hz,
5 % THD, 4 Ω load, both
channels driven)
Load impedance: 4 Ω (4 Ω to 8 Ω
(2 Ω for 1 ch) allowable)
Preout maximum output level: 2.0 V
Equalizer (13-Band Graphic Equalizer):
Frequency: 50 Hz/80 Hz/
125 Hz/200 Hz/315 Hz/500 Hz/
800 Hz/1.25 kHz/2 kHz/
3.15 kHz/5 kHz/8 kHz/12.5 kHz
Gain: ±12 dB
High pass filter:
Frequency: 25 Hz/31.5 Hz/
40 Hz/50 Hz/63 Hz/80 Hz/
100 Hz/125 Hz/160 Hz/200 Hz/
250 Hz
Slope: –6 dB/oct, –12 dB/oct,
–18 dB/oct, –24 dB/oct, OFF