Pioneer SPH-T20BT Benutzerhandbuch Seite 14

Rear view camera (ND-BC8)
(sold separately)
To video output
Rear view camera input
(R.C IN)
This product
Antenna input
Power supply
Power cord
Violet/white (REVERSE-GEAR
SIGNAL INPUT)
NOTES
• Connect only the rear view camera
to R.C IN. Do not connect any
other equipment.
• Some appropriate settings are
required to use rear view cameras.
14
En
USB
USB port
USB extension cable 1.5 m
NOTES
• Music and video in the connected
USB storage device can be played
back by attaching the tablet to
the holder. If detached, music and
video cannot be played back.
• Folders used on the tablet are
automatically created on the USB
device.
• When removing the USB device,
make sure to perform the removal
operation in advance by accessing
the storage settings on the tablet.
Failure to perform this operation
may result in data corruption or
need for repair.
Display
Rear display with RCA input
jacks
To video input
RCA cables (sold separately)
This product
WARNING
NEVER install the rear display in
a location that enables the driver
to watch the video source while
driving.
NOTES
• This product's rear video output
is for connection of a display to
enable passengers in the rear seats
to watch the video source.
• Only videos on the video player
application pre-installed on the
tablet can be output to the rear
monitor.
Installation
Important
• Check all connections and systems
before final installation.
• Do not use unauthorized parts as
this may cause malfunctions.
• Consult your dealer if installation
requires drilling of holes or other
modifications to the vehicle.
• Do not install this unit where:
− it may interfere with operation of
the vehicle.
− it may cause injury to a
passenger as a result of a sudden
stop.
• Install this unit away from hot
places such as near the heater
outlet.
• Optimum performance
is obtained when the
unit is installed at an
angle of less than 45°.
• When installing, to ensure proper
heat dispersal when using this
unit, make sure you leave ample
space behind the rear panel and
wrap any loose cables so they are
not blocking the vents.
Leave ample
5 cm
space
5 cm