Herunterladen Inhalt Inhalt Diese Seite drucken

Start-Up And Use; Stopping The Device - Lagrange Equilibre 229 Bedienungsanweisung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

START-UP AND USE

FIRST USE
When unpacking the appliance, take care to remove and
*
check all packing for parts as well as packets and additional
packing information.
Make sure that no parts or accessories are missing or defective.
*
Fully unwind the cable and carefully examine it before use.
*
Before using the appliance, clean the cooking surface and the drip
*
tray thoroughly with soapy water to remove any impurities from
the packaging. Dry thoroughly.
A new appliance may smoke and/or give off an odour when used
*
for the first time. To reduce the chance of smoking or odour, it is
recommended to allow the appliance to heat for
then cool for approximately
START-UP AND OPERATION
Place the appliance on a flat, stable, heat-resistant surface.
*
The device is suitable for outside use. It can be used inside under
*
an extraction hood.
Place the drip tray (see Image
*
Put the control button on the minimum setting and then connect
*
the connector to the rear of the product, making sure that it is
fully inserted (see Image
2
).
Then, connect the cable to the mains supply and turn the control
*
button to the maximum setting.
Let your Plancha preheat for
*
10
minutes and
minutes before the first use.
30
1
) on the front of the appliance.
to
minutes.
5
10
Once your appliance is preheated, adjust the thermostat to the
*
position of your choice and leave the food to cook until it has
been cooked to the desired extent.
NB: Do not cut anything directly on top of the plate or you will
*
run the risk of damaging the non-stick coating.
If you want to use the juice in the drip tray while the appliance
*
is on, all you have to do is carefully take hold of the two handles
on the ends of the drip tray and then pour the juice into a bowl
using the pouring spout.

STOPPING THE DEVICE

To turn off the appliance, turn the thermostat down to the
*
lowest setting.
Wait for your appliance to cool before unplugging the power cord
*
then the appliance connection block.
44
1
2

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis