Technoline WS 9136-IT Bedienungsanleitung Seite 26

2. Within 30 seconds, insert the batteries into Weather station (see
"Install and replace batteries in the Weather station"). Once
the batteries are in place, all segments of the LCD will light up
briefly. Then the time (as 0:00) and the weather icon will be
displayed. If these are not displayed after 60 seconds, remove the
batteries and wait for at least 30 seconds before reinserting
them.
3. After inserting the batteries, the Weather station will start
receiving data from the transmitter. The outdoor temperature and
the signal reception icon should then be displayed on the
Weather station. If this does not happen after 3 minutes, the
batteries will need to be removed from both units and reset from
step 1.
4. In order to ensure sufficient 868 MHz transmission, this should
under good conditions be a distance no more than 100 meters
between the final position of the Weather Station and the
transmitter (see notes on "Mounting" and "868 MHz
Reception").
5. Once the remote temperature has been received and displayed
on the Weather station, the DCF time (radio controlled time) code
reception is automatically started. This takes typically between 3-
5 minutes in good conditions.
Note:
Daily DCF reception is done at 02:00 and 03:00 every day. If the
reception at 03:00 is not successful, then at 04:00 and 05:00 and
06:00 there are other tries, until one is successful. If the reception at
06:00 is still not successful, then the next try takes place at 02:00 next
day.
If reception is successful, the received time will override the manually
set time. (Please refer also to notes on "DCF-77 Radio Controlled Time"
and "Manual Time Setting").
25