Maintenance And Care; Lubrication - Westfalia 92 86 23 Originalanleitung

on the snap ring.

Only use accessories specifically hardened and designed for use with
impact tolls. Do not use standard chrome type hand tool sockets and
accessories, as they may shatter and splinter.

Maintenance and Care

 To ensure proper functionality and a long lifetime, diligent lubrication
and maintenance is essential.
 For operating pneumatic devices clean air is required. Corrosion
residues, dust and dirt from the pneumatic pipes reduce the efficiency
of the tool and will cause technical problems. An upstream mainte-
nance unit consisting of filter, pressure regulator valve and lubricating
equipment removes moisture and dirt from the air, controls the working
pressure and supplies the tool perfectly with lubricating oil.
 If necessary, clean the air impact wrench with a moist cloth.
 Do not use abrasive or aggressive chemicals as benzene or thinner,
which may dissolve plastic parts.
 Do not allow liquids to enter the tool and never immerse it into liquids.
Water in the compressed air inlet can damage the machine. Therefore,
it is recommended to drain the air lines and the compressor regularly!
Also clean the air filters on a regular basis.

Lubrication

Pneumatic devices always have to be lubricated sufficiently. This is done
continuously and safest by using an oil-fog lubricator. If the oiler is
mounted centrally at the compressor or mounted firmly at the end of the
pipe installation, only use a hose with a length of max. 10 m. If the hose is
longer, the nebulisation disappears in the air. The oil floats inside the hose
and does not arrive at the air tool.
If you intend to use a supplied mini oil-fog lubricator, install it directly on
the compressed air connection (5) of the air impact wrench. Connect the
plug nipple to the other end of the mini oil-fog lubricator.
Operation
16