APP INVERBOOST XP11DCsiPX32 Benutzer- Und Servicehandbuch Seite 12

3.10 Drain out the water in winter for the units without drainage outlet in heat exchanger
Turn off the heat pump and be sure that it disconnected power
Turn off the water pump
- Close the valves 1 and 2
- Open the valve 4
Allow water to drain out over a long period until heat pump is fully drained.
NOTE: It need to close the valve 4 before turn on the heat pump.
3.11 Operating modes for optimal use
- TURBO: Used primarily at the beginning of the season because this mode allows very rapid temperature rise
- SMART: The heat pump has completed its primary task, in this mode; the heat pump is in a position to maintain
the pool water in an energy efficient manner. By automatically adjusting speed of compressor and fan the heat
pump delivers a better return.
- SILENT: In the summer months when the heat output is minimal required, the heat pump in this mode is even
more profitable. Added benefit; when the heat pump heats. It goes with minimal noise load.
10