Troubleshooting - Klarstein FAST FLAVOUR Bedienungsanleitung

TROUBLESHOOTING

Error Codes
Error Code E1
Problem Sensor trip-out
Troubleshooting
Problem
The lid is difficult to close.
The lid is difficult to open.
Steam escapes from the lid.
Steam comes out of the float
valve.
The float does not go up.
E2
Sensor short circuit
Possible cause
The sealing ring has not been
fitted correctly.
The float sticks to the push rod.
The float is still up after the
pressure has been released.
The sealing ring has not been
fitted.
The sealing ring is dirty.
The sealing ring is damaged.
The cover is not closed properly.
The sealing ring of the float
valve is dirty.
The sealing ring of the float
valve is damaged.
The float is blocked by the
plastic handle.
The pressure valve does not
close properly.
E3
Signal switch out of work
Solution
Attach the sealing ring correctly.
Gently push down the push rod.
Gently push down the float
with a chopstick.
Attach the sealing ring.
Remove the dirt.
Replace the ring.
Close the lid.
Clean the ring.
Replace the ring.
Contact a specialist company
for inspection or repair.
EN
25