Dust nozzle sets
For the trimmer base
► Fig.50: 1. Dust nozzle 2. Thumb screw 3. Trimmer
base
For the plunge base (optional
accessory)
► Fig.51: 1. Dust nozzle 2. Thumb screw
Use the dust nozzle for dust extraction. Install the dust
nozzle on the tool base using the thumb screw so that
protrusion on the dust nozzle fit to the notch in the tool
base.
Then connect a vacuum cleaner to the dust nozzle.
► Fig.52
MAINTENANCE
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
•
Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
Replacing carbon brushes
► Fig.53: 1. Limit mark
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
► Fig.54: 1. Screwdriver 2. Brush holder cap
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
•
These accessories or attachments are recom-
mended for use with your Makita tool specified
in this manual. The use of any other accessories
or attachments might present a risk of injury to
persons. Only use accessory or attachment for
its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
•
Straight & groove forming bits
•
Edge forming bits
•
Laminate trimming bits
•
Straight guide assembly
•
Trimmer guide assembly
•
Trimmer base assembly
•
Trimmer base assembly (resin)
•
Tilt base assembly
•
Plunge base assembly
•
Offset base assembly
•
Templet guide
•
Collet cone 6 mm
•
Collet cone 6.35 mm (1/4")
•
Collet cone 8 mm
•
Collet cone 9.53 mm (3/8")
•
Wrench 13
•
Wrench 22
Trimmer bits
Straight bit
► Fig.55
D
20
6
20E
1/4"
8
8
8
6
8E
1/4"
6
6
6E
1/4"
"U"Grooving bit
► Fig.56
D
6
6
6E
1/4"
16 ENGLISH
A
L 1
20
50
60
8
50
6
50
A
L 1
L 2
6
60
28
mm
L 2
15
25
18
18
mm
R
3