Speed; Maintenance - SPORTSTECH DESKFIT DFT 200 Benutzerhandbuch

COURSE
1
2
3
4
5
6
7
8
These values refer to a test person with 65 Kg. Therefore a deviation of approx. 10% can occur.
!
Caution:
CLEANING:
Remove dust regularly to keep the parts clean and for sustained durability. Be sure to wear clean athletic shoes
to avoid dirt getting into the treadmill. Treadmills are cleaned with a damp cloth, and with a little soap. Be careful
not to moisten the electrical components and the running surface.
CAUTION:
Make sure the power plug is pulled out before removing the motor cover, clean the interior of the device at least
once a month, and ensure that the electrical components do not get wet.
The footboard and running belt of the electric tread was lubricated in the factory. The friction between the
running belt and the footboard has significant impact on the product life and the performance of the electric
tread, so a regular application of grease is required.
APPLY SILICONE OIL:
Place the treadmill on the side, tilt it by 45°, then lift the running belt. Allow a small amount of oil to flow into
the centre of the footboard, as shown in the following illustrations.
Note: Please use the oil ecologically.

SPEED

MAINTENANCE

Prior to maintenance, make sure that the power plug of the
treadmill is pulled out.
33
SPEED (KM/H)
0.7
1.5
2.4
3.3
4.3
5.2
6.1
7.1
EN