Common Faults; Alarm And Prompt Facility; Processing Methods - KONUS tipitop robot S2 Bedienungsanleitung

Common Faults

Alarm and Prompt Facility

Tips: 1.If the cleaner stops working, it will emit the alarm sound "di di".
2.Please press the button "+" in the status of non-set state, the number displayed in the screen is fault code.You can
eliminate the faults according to the following steps.
Fault Code Reason
Er01 The ground detection
senors are bad.
Er02 The line contact of main
brush is bad, thus cause
the bad of motor.
Er03 Battery power is low.
Er04
Left and right wheels
are bad.
Er05 Dust box

Processing Methods

No. Faults
1
Walk back all the time
2 The cleaner does not work
3 The cleaner does not
charge automatically
4 The cleaner does not detect
the space isolator
5 The cleaner stops when it work
for a while
6 The cleaner can not charge
automatically
7 The remote control does not work 1. Check whether the installation of remote control is correct.
Warm prompt: if there are still faults after doing those steps like the solutions mentioned above, please keep contact with our
customer servicers.
Faults performance
1. Obstacles on the sensors
window.
2. Blocked on the step.
1. The main brush is blocked.
2. Hair and a strip of cloth
twine in the main brush.
1. The cleaner can not work
2. It can not charge
automatically.
1. The wheels are blocked
2. Hair and a strip of cloth
twine in the wheels.
1. No dust box in the machine
2. Poor installation of dust box.
Solution
1. It is better to avoid the cleaner working in the strong bright environment.
2. It is better to avoid the cleaner working in the black carpet.
3. Check whether the ground detection sensors is coverd by dust and other
things,please clean it with a piece of dry cloth.
1. Check whether the power switch is on and the power indicator is on.
2. Check whether the cleaner is enough power,if not,please charge the machine.
1. Check whether the LED indicator of charging station is on.
2. Check whether there are obstacles between cleaner and charging station.
3. When the battery power is low, please charge the machine artificially.
Check whether the installation of space isolator is correct. Turn on the power of space
isolator, check whether the power indicator is on.
Check whether the cleaner is in the mode of "spot cleaning" that it will only last about 3-5 min.
1. Check whether you use the original adaptor and insert the plug.
2. If the appearance of the cleaner is out of shape, damaged and so on. please stop using
the cleaner and call our customer servicers.
2. Check whether the signal receiver is dirty or damaged.
Solution Remarks
1. Clean the ground Clean the
detection sensors. ground detection
2. Take out the cleaner. sensors regularly.
Check the main brush and Clean the main brush
clean the main brush. regularly.
1. The cleaner change the The battery power is
charging mode exhausted, it can not
automatically. get back to the charg
2. Please charge the machine -ing station.
artificially.
Check the left and right Clean the wheels
wheels, clean the regularly.
entanglement on the left
and right wheels.
1. Install the dust box
2. Check whether the dust
box is installed properly.
EN
17