Charging Methods; Product Maintenance; Daily Storage; Clean The Main Body - KONUS tipitop robot S2 Bedienungsanleitung

3. When the cleaner is in "automatic cleaning mode",
"wall-following cleaning mode" or "spot cleaning
mode", if the power is not enough, the cleaner will
searching the charging station automatically.
Attention: If the cleaner can not find the charging
station when its power is enough, please match the
code again.
17
Steps to match Code:
1. Turn off the cleaner;
A
2. Press " FULL GO " and do not release;
3. Turn on the cleaner;
4. When you hear "di,di", the code match is right.
Attention: if do not hear "di,di", that means it is
failed, please repeat the above steps.

Charging Methods

18
Manual Charging
Danger ！ Electric shock!
A
1. Charge the machine with an adaptor: Connect
the plug between the machine and the adaptor,
then insert the socket.
Danger ！ Electric shock!
B
2. Connect the plug between the adaptor and
charging station, then put the machine behind
the charging station, put the charging electrode
on the charging station directly , finally connect
the power.
19
Auto Charging
1. Charge the machine with remote control:
A
Firstly, turn on the power switch, then press the
button "Charge", the machine will get back to the
charging station automatically on a certain range.
2. Auto charging:
B
When the battery power is low during the
cleaning, the cleaner will emit the sound "di di",
the main brush will also stop working， and the
machine will get back to the charging station
automatically.
Charge Button
C
Tips: When the cleaner enters the charging status, the
power indicator will twinkle. If the battery power is full,
the indicator will be on all the time.

Product Maintenance

Daily Storage

Tips: Please clean the cleaner regularly according to the
usage.
If the machine is not used for a long time, please charge
the battery fully, then take it out and put it in shade place,
keep the bottom of cleaner dry.

Clean the Main Body

1. Before clean the main body, please turn off the power
switch and take out the power plug.
2. Please wash the main body with water and neutral
detergent, and make sure the mop is dry, do not put the
water into the machine.
3. Do not wash the machine with oil.

Clean the Dust Box

20
Assemble and Disassemble the Dust Box
As shown on the photo, please press the button
A
"PUSH", then unpack the cover, finally take out the
dust box.
21
Clean the Dust Box
1. Pull out the buckle as shown on the photo, open
A
the top cover of dust box, then throw out the waste.
2. As shown on the photo, clean the dust box with
B
the clean brush.
22

Clean the Filter

1. Firstly disassemble the dust box according to the
A
above steps, then throw out the waste.
B
Filter Support
Filter
C
2. As shown on the photo, disassemble the filter
D
and support
(Tips:Please take care of the direction of filter
support, or else the cover can be not closed.)
3. Clean the dust in the filter with a clean brush.
(Tips: 5 times at most to clean the filter with water)
EN
15