Remote Control; Space Isolator - KONUS tipitop robot S2 Bedienungsanleitung

Spot Cleaning
B
2. Turn on the power switch, the power indicator
will be on. Press the button " SPOT " in the remote
control, the machine will start cleaning partially,
the cleaning range is about 1m 2 . Then you press
the button " SPOT ", it will stop.
Wall Following Cleaning
C
3. Turn on the power switch, the power indicator
will be on. Press the button "
remote control, the machine will start cleaning
behind the wall. Then you press the button
"FWALL", it will stop.
Auto Charging
D
4. Turn on the power switch, the power indicator
will be on. Press the button "
start seeking the charging stattion; press the button
again, it will stop seeking the charging station.
When it is being charged, the indicator twinkles.It
is being charged fully, the indicator is on all the
time.
Tips: when the battery power is low, the machine will
emit the sound "di di", the main brush also stops and
will seek the charging station automatically.
13

Remote Control

Signal Indicator
A
Power Switch
B
Auto Cleaning
C
Wall Following
D
Spot Cleaning
E
Forward
F
Left
G
Right
H
Back
I
Auto Charging
J
Battery Pack
K
14 Usage Guidance of Remote Control:
Power Switch
A
Signal indicator
B
The cleaner will work according to the mode
C
"Auto cleaning"
The cleaner will work according to the mode
D
"Spot cleaning"
The cleaner will work according to the mode
E
"Wall following cleaning"
The cleaner will search the charging station
F
Walk forward
G
Walk back
H
" in the
Walk left
I
Walk right
J
Tips: If the remote control does not work, please check
the battery power, if it is enough power, please match
code again according to the following steps:
", the machine will
Steps to match code: (Make sure the cleaner and
K
remote control have enough power, then do the
following steps）
A.Turn off the cleaner ；
B. Press the button"
C. Turn on the cleaner ；
D. After hearing the sound "di di", loosen the
button"
successful.
Tips: if you do not hear the sound "di di", it means
that the operation of code match is wrong, please
do it again.
15

Space Isolator

A Power Switch
Code Match Button
B
Signal Window
C
Power Indicator
D
Usage: 1. Turn on the power switch, the power
E
indicator twinkles
2. Put the space isolator on the flat floor
and behind the wall.
(Tips: Put the space isolator back to the wall, or
else the cleaner will push the space isolator on the
back or side.)
Tips: If the space isolator does not work when the
power is enough, please match code again.
Steps to match code:
A: Turn off the cleaner, and turn on the Space
Isolator (with power indicator on);
"all the time ；
", the operation of code match is
EN
13