Product Formation; Main Body And Accessories; Accessories Introduction; Product Installation - KONUS tipitop robot S2 Bedienungsanleitung

Product Formation

2

Main Body and Accessories

Remote Control -1pc
A
Space Isolator -1pc
B
Charging Station -1pc
C
Main Body -1pc
D
Battery -1pc
E
Adaptor -1pc
F
Trailing Bar Assembly -1pc
G
Screwdriver -1pc
H
Clean Brush -1pc
I
Adaptor -1pc
J
HEPA Filter -2pcs
K
Side Brush -4pcs
L
Instruction -1pc
N
Tips:
- There is a side brush and a filter assembled in main
body, and another two side brushes and a filter is
inside.
- The trailing bar assembly includes a mop that can be
used directly.
3

Accessories Introduction

Front View
Indicator
A
Cover
B
Power Switch
C
Signal Window
D
Bumper
E
Wall Detection Sensors
F
Back View
Dust Box
G
Battery Pack
H
Button
I
4
Bottom View
Side Brush
A
Charging Electrode
B
Front Wheel
C
Main Brush
D
Right Wheel
E
Side Brush
F
Ground Detection Sensors
G
Charging Jack
H
Left Wheel
I
5
Mop
A
Trailing Bar Assembly
B
Trailing Bar
C

Product Installation

6

Main Body

Please take down the battery when the cleaner is
not used for a long time!
Connection: inset to the terminal
Disconnection: extract in the opposite direction
1. Loosen the screw with screwdriver to unfold the
A
battery cover.
2. Connection method: take out the connector
B
between the battery and cleaner, join the two
terminal, take care of the relevant color. Method to
disassemble the pin: unplug the pin in inverse
direction.
3. Put the battery in battery container (see the
C
above picture), then put the terminal and wire in
the container (see top right picture), finally, close
the battery cover and tighten up screws.
EN
11