inda A0452D Bedienungsanleitung Seite 5

G ll the components of the hair-dryer, including the movable part at
maximum extension, must be kept out of reach of anybody using the
bathtub or the shower.
G Do not use hair-spray while the appliance is switched on.
INST LL TION:
Fasten the appliance inside the drawer with three D screws (not provided).
G Drill a hole into the drawer and place an insulating rubber cable duct E to insert the power
cable.
2 W LL F STENING (1). Prepare a branch box F and a pipe G with outlet at a distance
of approx. 10 cm. F STENING TO THE PIECE OF FURNITURE. Fasten the terminal
board to a fixed part of the piece of urniture using 4 screws H (not provided). Do not
fasten the terminal board to the drawer.
3 Insert the mains wiring into the supplied sheathing I.
1 Insert the cable into the pipe G.
G Open the terminal board L with the help of a screwdriver.
G Loosen the cable clamps M and N.
G Insert the cable of the hair-dryer into the cable duct O and connect the wires to the terminal
board.
G Fasten the cable clamp M making sure the sheathing is kept inside the terminal board.
G Insert the mains wiring and the sheathing I into the cable duct P and connect the wires to t
he terminal board.
G Fasten the cable clamp N making sure the sheathing is kept inside the terminal board.
G Close the terminal board.
1 Insert the terminal board into the branch box.
G Make sure the mains wiring is not in contact with any sharp edges. he opening and closing
of the drawer should not cause any crushing of or damage to the wires or the insulating
sheathing of the equipment.
USE:
- Support switch.
B - Hair-dryer switch.
C - Cursor.
fter use, switch off the hair-dryer and turn support
G
G In case of overheating due to improper use, the hair-dryer turns off automatically. In this
case, turn the support switch to 0 and release the switch B of the hair-dryer. Once the cau
se of overheating is removed, the appliance is ready for use after a few minutes.
I
TTENZIONE:
G Importante: per garantire una protezione supplementare si consiglia di
installare nell'impianto elettrico, con il quale viene alimentato
l'apparecchio, un interruttore differenziale con una corrente di intervento
switch to 0 (off).
5