ABNOX AXDV-P50 Montageanleitung Seite 48

EN
Switching on
WARNING! Risk of injury!
Only trained qualified personnel may switch the device on and off in
accordance with the safety and accident prevention regulations.
1. Switch on power supply.
2. Switch on control air supply and material supply.
3. Turn on device at plant controller.
4. Check that device is functioning and operating correctly.
5. Check that device is within all the specified set value ranges.
Switching off
1. Shut down device at plant controller.
2. Switch off control air supply and material supply.
3. Switch off power supply.
Shutdown
Before shutting the device down for an extended period, the following steps must be
taken in accordance with the safety regulations:
 Switch off device (see chap. "Switching off") and prevent it from being
switched back on.
 Remove material residue from the device.
 Clean device inside an out (observe chap. Maintenance)
 The medium must be removed and properly disposed of.
ATTENTION
The various materials /liquids must be properly and separately handled
and disposed of in compliance with the applicable national ordinances.
Lubricants are considered hazardous waste.
48